auszookers.com • View topic

Board index » Talking About Stuff » N00b Talk

Oil leak

Page 1 of 1

[ 20 posts ]

Print view

Previous topic | Next topic

Author

Message

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 7:32 am

My oil sump has been leaking for a while now so I put a new sump gasket in.also my main seal has been replaced not long ago.but there is still an oil leak around the sides and bottom of the gearbox.any ideas what this might be.

BlueSuzy

az supporter

Joined: Sun May 04, 2008 11:30 pm
Posts: 9711
Location: NSW
Vehicle: SJ51 LWB, SJ70 SWB

Posted: Wed Aug 01, 2012 8:34 am

Rear main again
Sump not sealed properly
Gearbox input seal
Gearbox input casing not sealed right
Small plate on back of motor leaking

_________________

BlueSuzy wrote:

I'm over the G16b's.

stockman

az supporter

Joined: Thu Nov 05, 2009 10:30 pm
Posts: 5319
Location: Canberra
Vehicle: 4wd

Posted: Wed Aug 01, 2012 8:44 am

Also check dizzy seals. When they go oil runs down the back or the motor.

_________________
Watch out or you'll get sued.

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 9:27 am

I've been.its been doing this for a while now.ive checked my oil levels and I'm not loosing any.when I had the sump leak could there be oil in the gearbox housing and the fly wheel flicking the oil out.

abclarke

Joined: Mon Feb 14, 2011 8:19 am
Posts: 1966
Location: Couridjah
Vehicle: 1985 Holden Drover

Posted: Wed Aug 01, 2012 9:35 am

Are you sure it's not old oil from beforehand?

_________________
1989 WT Sierra.

BlueSuzy

az supporter

Joined: Sun May 04, 2008 11:30 pm
Posts: 9711
Location: NSW
Vehicle: SJ51 LWB, SJ70 SWB

Posted: Wed Aug 01, 2012 9:47 am

BlueSuzy wrote:

Gearbox input seal
Gearbox input casing not sealed right

_________________

BlueSuzy wrote:

I'm over the G16b's.

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 9:54 am

I'm pretty sure its not.it's been doing it for a while,so I'm sure the old oil would have gone by now surely.

caboose

Joined: Sun Aug 14, 2011 2:07 am
Posts: 64
Location: perth

Posted: Wed Aug 01, 2012 9:57 am

clean it. take it for a blatt, and see if the oil leak comes back

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 10:03 am

Can I clean it without taking the gearbox out.it won't hurt it if I spray decreased in the housing.

caboose

Joined: Sun Aug 14, 2011 2:07 am
Posts: 64
Location: perth

Posted: Wed Aug 01, 2012 11:09 am

At it. Not in it. Try to avoid the electrics as well

KEENSY85

Joined: Wed May 09, 2012 12:46 am
Posts: 1742
Location: north brisbane
Vehicle: 1985 lwb sierra UTE

Posted: Wed Aug 01, 2012 5:17 pm

look at were ur shifter bolts also the prevouse might not have bolted the shifter plate up properly and might be spashing out

_________________
Green? greeeen is nice !

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 5:33 pm

It's coming from inside the gearbox where the metal plate cover is,that covers your fly wheel. And it's definitely engine oil

mrw82

az supporter

Joined: Tue Jul 03, 2007 11:30 pm
Posts: 1350
Location: stuck in a hole. not off road, just deception bay.
Vehicle: snotbox, 84 LWB sierra 1 litre

Posted: Wed Aug 01, 2012 6:14 pm

Rear main seal. That's a gearbox out job to replace.

KEENSY85

Joined: Wed May 09, 2012 12:46 am
Posts: 1742
Location: north brisbane
Vehicle: 1985 lwb sierra UTE

Posted: Wed Aug 01, 2012 6:50 pm

mrw82 wrote:

Rear main seal. That's a gearbox out job to replace.

pretty easy job for ya 30min ether way

_________________
Green? greeeen is nice !

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 7:02 pm

Ok thanks mate.

Deego

Joined: Fri Mar 23, 2012 11:04 am
Posts: 187
Vehicle: Suzuki sierra

Posted: Wed Aug 01, 2012 7:04 pm

It's been doing it for a while but I'm not loosing any oil

want33s

az supporter

Joined: Fri Nov 16, 2007 10:30 pm
Posts: 8135
Location: Sunshine Coast Qld

Posted: Thu Aug 02, 2012 6:52 am

Deego wrote:

It's been doing it for a while but I'm not loosing any oil

If you weren't losing ANY oil you wouldn't have a leak, would you?

Even one tablespoon of oil is enough to make a mess but not enough to notice down on the dipstick.

Engine oil coming out of the bottom of the bellhousing is a leaky rear main seal as has been said a few times already.

Scales

az supporter

Joined: Mon May 30, 2011 9:28 am
Posts: 2233
Location: Townsville
Vehicle: 03 Jim M13A no-vvt, Vinyl Spec

Posted: Fri Aug 10, 2012 11:58 am

i rekon its the rear main seal.... anyone else?

_________________
MY BUILD THREAD HERE!!!!!

TZAR

az supporter

Joined: Tue Aug 01, 2006 11:30 pm
Posts: 3459
Location: licking some windows
Vehicle: LJ20 LJ50

Posted: Fri Aug 10, 2012 12:04 pm

rear main seal :deadhorse:

atari4x4

az supporter

Joined: Mon Dec 11, 2006 10:30 pm
Posts: 34843
Location: East Radelayed
Vehicle: SV420+SV620 Vitara's

Posted: Fri Aug 10, 2012 12:11 pm

Page 1 of 1

[ 20 posts ]

Board index » Talking About Stuff » N00b Talk

Who is online

Users browsing this forum: No registered users and 25 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum