[Andygoodbloke]

Hi all
I am asking for help please.
I have purchased a back seat out of a 98-18 Jimny to fit in my SJ413. The width fits perfectly between the wheel arches

It has different mounting points of course but most can be fabricated easily apart from one. The seat back has a bracket which mounts to the floor in the middle with the seat belt mount, the other side on the outside of the seat has a round ball which sticks out of the trim. I need to make this mount and you can purchase small stainless balls with a thread on the inside. How big is the diameter of the mounting ball which goes onto the seat back and allows a swivel and different positions/ folding flat. Apparently they are permanently attached and the person who sold me the seats had used them for an anchor point for storage so could not ask for them.

Can some one who has removed their back seats please advise the diameter

Once I have this diameter I can make the bracket.

Thank you Andy

[Andygoodbloke]

Don't worry I have found a M10 bolt will do it

Thanks Andy