[Gussyb]

I just got a new column switch because the headlights didn't work with the old one. everything else worked. I connected it up and the windscreen washers/wipers, horn and headlights work but now the hazard lights and indicators don't work. my car is a Holden drover and I bought a Sierra switch. I was told that it wouldn't fit my drover and it didn't. the mounting points were wrong. I drilled parts so they would fit and i'm sure that the circuit board wasn't hit.
Anyone got any idea
Thanks
Gus

[4x4xzook]

Check the listing you bought.

https://www.ebay.com.au/itm/COMBINATION ... SwZn1fkYgh

This says its for a holden drover, did you buy the right column switch?

[fordem]

WHY are you starting a new thread on this?

https://auszookers.com/forum/viewtopic.php?f=37&t=56818

Is this the same switch or a new one? I got you the relevant diagrams, everything you needed to sort the problem out, or at the very least determine that the switch was not compatible - perhaps it's time to take the car to an auto-electrician.