[prickle]

Collective grey matter.

I have searched .. honest I have .. just been on Gumtree and found these .. will they fit (and pass a going over the pits for rego) a stock standard Serria LWB .. with a WT front clip

30x9.50 maxxis buckshot mudders on 15x6, neg 5 offset sunraysia rims

Stuart

[Gwagensteve]

No and no, in short

You will have contact between the tyre and the bumper outriggers, and the guards. It's not hard to overcome, but they don't clear a standard car.

No, 30's are 4" taller than the standard tyres, so no, they aren't legal. There is a proviso to this though. If you have a "commercial" model with 16" rims specifically mentioned on the tyre placard, you might be ok on a 30" tyre as the 6.50 16's fitted to these models are 28" tall.

[alien]

^^ What he said.

If you're going over the pits keep it stock as a rock and fit your 30s later. The pits will pick on EVERYTHING, so don't give them ammunition.

When i went over the pits with mine they made me tighten a wheel bearing that had about 1mm of play in it on a 31" tyre. Sure, it needed snugging up, but they wrote that it needed immediate replacing with a new bearing. They're brutal. They also wrote me up to fix "Holes in the floor" - as i had my floor bungs out and sitting to the side of the holes under my floor mats. I offered to pop the bungs back in right infront of the guy and he refused to allow it, and wrote it up. I put them back in while he was pacing around the rest of the car. They also check any movement in your seat mechanisms and that all the adjustments work...

[prickle]

Hmmm dont really want to put new tyres on stock rims just for rego ... might have to borrow some for the day