[josh green]

it seems as if the 4wd gear stick is stuck in neutral,i cant seem to move it. i hope this uis just a nood thing on my behalf. any suggestions?
also my handbrake doesnt make the ratchet noise when putting the hand brake on?

thanks, Josh Green.

[Fatzook]

Josh,

You need a new shifter bush. PM myself or bruce. We can fix you up with a new one

[josh green]

do you know anything about the handbrake?

[abclarke]

josh green wrote:

do you know anything about the handbrake?

Afaik thatd just be the teeth clicking over?

[josh green]

yeah it doesnt make that noise

[abclarke]

Can you see what the lever is doing when you pull it up?

[josh green]

not really cos there is a center console

[Red89]

Does it lock on ? Does the button in the end of the handle pop in and out ?

[josh green]

yeah it does

[Rossco]

When my lever was stuck in neutral it was packed full of sand. I just pulled it out on the track and got it all out. Might be worth a look, but having said that it's probably the shifter bush

[sideways]

Fatzook wrote:

Josh,

You need a new shifter bush. PM myself or bruce. We can fix you up with a new one

Hey Pete, can you get the bush that suits the early non-switched case?

[Fatzook]

sideways wrote:

Fatzook wrote:

Josh,

You need a new shifter bush. PM myself or bruce. We can fix you up with a new one

Hey Pete, can you get the bush that suits the early non-switched case?

I have a heap here. I wasn't aware of any difference. Got a pic?

[sideways]

Fatzook wrote:

sideways wrote:

Fatzook wrote:

Josh,

You need a new shifter bush. PM myself or bruce. We can fix you up with a new one

Hey Pete, can you get the bush that suits the early non-switched case?

I have a heap here. I wasn't aware of any difference. Got a pic?

No pictures because I don't have a bush, it's actually worn a nice groove into the transfer body! The old one was just a few tiny chunks of plastic scattered throughout the case.

As far as I can tell, it's just a smaller diameter and a bit shorter. Suzistore said they were the same (I asked after an eBay seller said they were different) so I bought their shifter kit and the only bit that fitted was the boot (didn't try the detents ect) but the collar and bush were slightly to large to fit. The bush kinda fitted but it disintegrated whilst I was trying to fit it. The diameter was to large and it didn't fit under the bolt that guides the stick.

I've been running it with no bush for months now, it's always a nervous moment when I shift into low range.