[IN2DEP]

Hey guys

How hard is it to remove an ARB Bull Bar with winch ??

Im going to take it off and cut back the out riggers then take it to the shop and get them to custom fit it

cheers
keith

[sogone]

Not very hard. 3 bolts each side.

[abclarke]

Yep as sogone said, simple enough taking the bolts out BUT you might want a hand from someone else to support it or stick some stands under to take the weight.

[IN2DEP]

is the winch bolted to the bar ?? do i need to take off the rollers first ??

[atari4x4]

how about going outside & having a look?

[IN2DEP]

atari4x4 wrote:

how about going outside & having a look?

No point looking if i dont know what im looking for, now i know where and what to look out

Thanks guys for the help

[Scrawny]

Just keep undoing bolts till it falls on your head

[JrZook]

^^^ This guy!

[IN2DEP]

Scrawn wrote:

Just keep undoing bolts till it falls on your head

Hahhaha I like that one

[IN2DEP]

no need to take the bar off, I unbolted the 3 bolts on the out riggers then used my 4" grinda to cut them off, might have to bash the seems back at the back of the wheel arch, but i took it for a drive around the block and no scrubbing on the 32s

but thats no flexing at all, but bumpy as all f@#k but im still running the stock shooks witch they are full open just sitting there so next thing is, is to weld the shock mounts on

Oh and ill have to custom mount the bull bar, there is no way it can hold with just the center bolts, the bar is moving up and down

[jimbo_jones]

Yeah you will need to beef up the mounts don't use the winch till you do

[IN2DEP]

jimbo_jones wrote:

Yeah you will need to beef up the mounts don't use the winch till you do

Well thats good then lol my winch is bugged anyway lol