[RIKSTR]

I have a whole G16B I want to get rid of.
The cam is actually a performance cam cut with a hi-torque profile, with really good power from about 2000-5000.
Head could do with a re-build, valve stems need doing.
Bottom end knocked due to low oil pressure so I shut it down and swapped it out. Block itself is a good one no coolant leaks.
Its got a sump, baleno rocker cover (from engine swap), dizzy angle drive no dizzy.
Its sitting in my shed, on an engine stand, under a cover.

$600, pick up only, located in Canberra

I was going to rebuild it and sell it but I just dont have the time.

[Llewellyn92]

Looks like its had a hard life with lack of oil changes, if it was in better condition i would of jumped at the offer, good luck with the sale.

[oozuk]

do you have paperwork or proof that its not a STD cam

[RIKSTR]

Yea good point I have only really gone off the word of the guy that owned the car before me, he was into rallying and with the amount of money spent on the car in other areas I had no reason to doubt him.
It did perform much better that a std vitara, pulled hard from 2000 to 5000, but I don't have any specs.

llewellyn, as stated it will need a build, if it didn't I would be asking for more money