[zookprojectfnq]

A while ago I saw someone had come up with a better Idea then using a rubber glove to seal the twin sticks to the transfer box. I have an issue with water getting in and need a solution. It was machined out of alli and used an oring seal and clamped on the top with 2 grub screws. It then had a Heavy duty boot for each stick? Im chasing pics or diagrams so I can machine one up. And I have done a search

[Damo]

What twinstick do you have? Evil Twin?

I've got the Rock4x fabrication one, and I think it's the one you're thinking of. I don't think the boot is going to work with the evil twin setup though.

The Rock4x one is here

[lump_a_charcoal]

That is the one I have, and pretty sure they are evil twin...

Bloody fiddly to install though, have to remove the front prop shaft to install/remove it.

[MART]

This is the one I had if it helps , Cheers Paul.

[zookprojectfnq]

Yeah that is the one. Mine are evil twin sticks from locktup but they dont come with the little boot on the top of the transfet to stop it filling up with water. Do you reckon that little boot would fit mine damo

[Damo]

lump_a_charcoal wrote:

That is the one I have, and pretty sure they are evil twin...

Bloody fiddly to install though, have to remove the front prop shaft to install/remove it.

The rock4xfab one is different to the evil twin. I have the rock4x one and it was a FUCKING MOLE to install. I rue the day I have to take my tcase out again

From what I can see the rock4x boot wont fit the evil twin, the shifters are different shape, the rock4x boot is made for round shafts, i'm guessing they're 1/2" dia.

[zookprojectfnq]

Done some more searching through old posts. This is what i need but you are right damo. the evil twins are flat bar shafts then the round bar welds on. I can machine a holder up. Its the rubber boot thats going to be difficult to obtain
http://i7.photobucket.com/albums/y270/M ... apter2.jpg

[Damo]

zookprojectfnq wrote:

Done some more searching through old posts. This is what i need but you are right damo. the evil twins are flat bar shafts then the round bar welds on. I can machine a holder up. Its the rubber boot thats going to be difficult to obtain
http://i7.photobucket.com/albums/y270/M ... apter2.jpg

Check that link I posted earlier in the thread, you can buy the alloy bit and the boot for US$44.