[hamblock]

Hello!

I recently replaced the head gasket on my G13B swapped Sierra and have put it back together and tried to start it running and just doesn't get going even with some ether and/or a pull of the throttle.

Discussion with step-dad made me realise in my stupidity I have rotated the crankshaft while the timing belts were taken off.
So even though I marked the timing belt with the camshaft pulleys I forgot that one tiiiiiny step of keeping them in line with the crankshaft.

Is there an easy way to get the crankshaft and the camshafts back in time?
Like some marks on the block or something similar?

Been trying to look all around the internet and just keep getting shown G16B or G13BA and thought I'd give the forum a whirl.

TLDR:

How do I get the camshafts and crankshaft back in time with each other.

Cheers!