Was bored this arvo so I went out to tinker with my zook I had a new cooler/warmer in my gararge that has been sittin there for about a year I tryed it in behind the seats and fitt good except for the drop in the tunnel so I decided to make a cradle to sit it in.
this is the cooler
I measured the cooler and cut some alloy angel up to suit
then I sat it all together to see if it fit
it fit well so then I drilled and pop rivet it together
then I cut some bits of the alloy to go on the corners
my cooler has rounded corners so I had the pop rivets facing in for looks
next I needed some legs to support it where the tunnel drops I bent a bit of alloy up and pop riveted it into place
I tryed it in the zook fit good the gave it a lick of paint
then once dry I screwed it down into place and fitted the cooler
all up took about a hour and a half to make nice and easy
hope this helps some one
cheers jimbo