auszookers.com • View topic

Board index » Talking About Stuff » Suzuki Talk

4wd light switch

Page 1 of 1

[ 4 posts ]

Print view

Previous topic | Next topic

Author

Message

607CHA

az supporter

Joined: Thu Apr 07, 2011 8:21 pm
Posts: 265
Location: Baldhills
Vehicle: 02 jimny

Posted: Thu Oct 20, 2011 6:41 pm

Put my 6.5 gear set in and with all the moving around i snapped off one of the wires for the 4wd light switch. 2 questions. can it be taken out without dropping the oil and if can would it be better yo buy a new one or try and solder the one i got

_________________
LIVING LIFE ON THE EDGE, TILL YA ROLL

tonyevans

az supporter

Joined: Sun Jan 16, 2011 11:18 pm
Posts: 1998
Location: Lightning Ridge NSW
Vehicle: SJ40 - LJ50 - LJ50V - Vitara

Posted: Thu Oct 20, 2011 7:41 pm

New ones are cheep and its hard to keep moisture out after soldering.

_________________
Old farts sometimes know some stuff you don't.

want33s

az supporter

Joined: Fri Nov 16, 2007 10:30 pm
Posts: 8135
Location: Sunshine Coast Qld

Posted: Thu Oct 20, 2011 8:06 pm

The wire is most likely broken where it goes into the resin on top of the switch leaving nothiong to solder the wire back onto.
www.suzistore.com.au sell new switches for NT or WT for about $35 delivered I think.

SierraDan

az supporter

Joined: Fri Feb 04, 2011 10:55 pm
Posts: 9347
Location: Newcastle
Vehicle: G13BB Jimny

Posted: Thu Oct 20, 2011 11:25 pm

and dont need to drop the oil.

_________________
mlm

Page 1 of 1

[ 4 posts ]

Board index » Talking About Stuff » Suzuki Talk

Who is online

Users browsing this forum: No registered users and 37 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum