[BUZOOKA]

ok first noticed this when i had the 31s on the rear that the diff sits 2 the left about an inch not really sure wat i could be

im thinking maby a bent hanger but it seems to handle fine


plz help

[coneykid]

mine dose it to. but i think mine is due to 2 inch shackel lift

[BUZOOKA]

yer mines alll standard so that aint it butm could still eb hanger/shackel

[OMalley]

Mine does it too, both on the front and rear. But i have a dodgy shackle on the front.

[Highway-Star]

Poor rear axle manufacturing tolerances?
My widetrack has a rear axle that measures somewhere between narrow track and widetrack. Can visually see that the rear is narrower than the front just quickly looking at my car, as its a good 20 or 30mm under length. Its also slightly offset to one side (can't remember which now, but its only about 5mm). Not as bad as Hiluxes which seem to notoriously have different wheelbases on each side of the vehicle

If it bugs you too bad, find another axle, and measure it up before you buy it, then swap it in. I've personally been driving my car for over 5 years now, and it has not bothered me at all

[BUZOOKA]

o ok well if its just a common fualt then it doesnt worrie me so much i just thought it was something twisted or stuffed that's all

cheers highway star

P.s if any one else could come forward and give me a confirmation or a different diagnosis im more then happy to listen


cheers luke

[steak_knife]

BUZOOKA wrote:

o ok well if its just a common fualt then it doesnt worrie me so much i just thought it was something twisted or stuffed that's all

cheers highway star

P.s if any one else could come forward and give me a confirmation or a different diagnosis im more then happy to listen


cheers luke

Suzuki's don't have fault's, thay have blemishes.

[royce]

Character, the word is character

[steak_knife]

royce wrote:

Character, the word is character

Yes boss!!!

[Highway-Star]

Makes them all individuals

[steak_knife]

Highway-Star wrote:

Makes them all individuals

Just like me, me ,me ,me, me, me & me!!

[shandy92]

i no this is probably different, but i have this on the rear of my vitara. one side sticks out by about 15-20mm and the other side is in by 15-20mm. just stock vitara but with 235/75/15 on sunnies. it was the same on my last vitara with same setup.

u cant really notice it tho as i have flares

Mitch

[steak_knife]

On a vit I would be looking for worn bush's or movement in the center hemi joint, 10-15mm is not a lot tho.

[bron5on]

Yep, noticed my wheels stuck out a bit when I first did my lift and tyres. Even more so when I added shackles to the equation. Worried me at first but seems to be a common thing.

[JrZook]

BUZOOKA wrote:

ok first noticed this when i had the 31s on the rear that the diff sits 2 the left about an inch not really sure wat i could be

im thinking maby a bent hanger but it seems to handle fine


plz help

Where are you referencing it from? The body? Is it straight? Im assuming that all your rims are the same as well ie offset.

Dan

[89_tintop]

my sierra also sticks out.. but i am sitting on sagged rims on the drivers side..

if you jack the chassis up till it sits all nice and even then the wheels sit equally out of the guards

its all a visual thing.