[tanked]

Hi all its time i am selling my mighty sierra, I am suffering from sore back syndrome and also not using it much as well. it does have issues and needs some work...
cost 15,000 or Correct type of non lams road bike to around 8k plus cash..

Engine 2010 m15a Aprpxx 80k on it when I bought it had 63k on speedo off car and hasnt been driven to much
gearbox 2004 non vvt jimny box with conversion to bolt into sierra, when open new seals and bearing throughout
Transfer 4.9s with ring
Front diff TRE air locker
Rear Diff TRE air locker but the ring and pinion damaged
Astra electric steering pump
3500lbs winch
Davis Craig electric water system with screen
Haltec Elite 550 to run engine
2006 Subaru Outback front seats
Twin Yellow top agm batteries
Car has been mod plated for the engine, gearbox, power steering pump and the seats
Has 30*11.5 TSL super swampers fitted
Rock sliders (hot dipped galvanised)
Air tank on board with lines run to rear of car and bonnet
Couple month old EFS 2" lift with neoprene bushes though out
Comes with spare fuel tanks although damaged always handy to have, few spare starter motors, spare alternators and full set of spare wheels among other few random parts

Now some of the bad
Has some rust in it not bad but needs to be adressed
Reverse lights arent connected need to be run from gear box and wired
The rear diff ring and pinion is no more
No hoses run to heater box and system , just havent got around to connecting it
Will be sold as is no rwc, I can get a car trailer if needed and can get it to you within reason

Area Redbank plains
Contact please TXT 0426 528 265 any question please text as i rarely get to the pc, will send photos when asked

[tanked82]

I now have an open rear diff in the car and a new clutch cable, and am driving it again, still same price

[tanked82]

may have the rear locker re installed shortly

[vet 180]

I genuinely didn't understand the price?

Sent from my SM-N960F using Tapatalk

[JimPollard]

Hi mate,
Did you end up selling it?
How did the Subaru seats fit in?
Did they mount up to the original rails or need fab work?
Sorry for all the questions I’m in the middle of working out the best way to go with new front seats on mine.
Cheers