auszookers.com
https://www.auszookers.com/forum/

1994, 1 litre 4 speed and transfer rebuild
https://www.auszookers.com/forum/viewtopic.php?f=5&t=9728		 Page 1 of 1
Author:  shantillylais [ Mon Feb 08, 2010 5:35 am ]
Post subject:  1994, 1 litre 4 speed and transfer rebuild
is this a difficult job for a reasonably skilled mechanically minded person? If its not hard, are kits (I assume bearings and seals) available, and where from? SA based, but just as close to Melb as Adelaide so will need to be freighted.
Author:  ninjadaniel [ Mon Feb 08, 2010 1:53 pm ]
Post subject:  Re: 1994, 1 litre 4 speed and transfer rebuild
i did it, took around 2-3hrs. Youll need a press and some patience- remember to remove the speedo drive gear first!! :)

I think the hardest part might even be getting the flange nuts off the inputs/outputs.
Author:  shantillylais [ Mon Feb 08, 2010 3:42 pm ]
Post subject:  Re: 1994, 1 litre 4 speed and transfer rebuild
kits/parts, suppliers? Any ideas where from, eg where did you get yours?
Author:  Hybrid [ Mon Feb 08, 2010 4:17 pm ]
Post subject:  Re: 1994, 1 litre 4 speed and transfer rebuild
http://locktup4x4.com.au/ these guys ship quick. I've rebuilt a 5 speed and a transfer with their kits. Not had a drama. Get a cheap press though.
Author:  Ben_Sierra [ Mon Feb 08, 2010 4:38 pm ]
Post subject:  Re: 1994, 1 litre 4 speed and transfer rebuild
Hybrid wrote:
http://locktup4x4.com.au/ these guys ship quick. I've rebuilt a 5 speed and a transfer with their kits. Not had a drama. Get a cheap press though.


I got a cheap press for doing my transfer...

Its called a 3lb club hammer :D
Author:  Hybrid [ Mon Feb 08, 2010 6:56 pm ]
Post subject:  Re: 1994, 1 litre 4 speed and transfer rebuild
"pressed' a few bearings before with a lumpy. Upgraded to a $100 press and I'll never go back. :)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/