Could be morse code....no sseriously,write down the taps in order of interval....
You need to sequence the taps so they run at 40 thou over..
Then you have your benchmark...these guys can elaborate.....
jeannie arses....
| auszookers.com https://www.auszookers.com/forum/ |
|
| tapin noise https://www.auszookers.com/forum/viewtopic.php?f=5&t=7031 |
Page 1 of 1 |
| Author: | seen [ Mon Oct 05, 2009 11:09 pm ] |
| Post subject: | tapin noise |
hey i hav a taping noise coming from my engine i am just wonderin what u guy think it could be |
|
| Author: | steak_knife [ Mon Oct 05, 2009 11:25 pm ] |
| Post subject: | Re: tapin noise |
seen wrote: hey
i hav a taping noise coming from my engine i am just wonderin what u guy think it could be If it`s ya mower, the cat`s under it.. |
|
| Author: | 89_tintop [ Mon Oct 05, 2009 11:42 pm ] |
| Post subject: | Re: tapin noise |
could be your tappets. they just need adjusting. or worst case could be piston slap |
|
| Author: | steak_knife [ Mon Oct 05, 2009 11:57 pm ] |
| Post subject: | Re: tapin noise |
Could be the timing cover, cam belt, alt belt, loose bracket, cat coverter, compression leak, ect ect ect |
|
| Author: | Cozook [ Tue Oct 06, 2009 12:10 am ] |
| Post subject: | Re: tapin noise |
Could be morse code....no sseriously,write down the taps in order of interval.... You need to sequence the taps so they run at 40 thou over.. Then you have your benchmark...these guys can elaborate..... jeannie arses....
|
|
| Author: | ZOOKCREW [ Wed Oct 21, 2009 10:13 pm ] |
| Post subject: | Re: tapin noise |
my noise was gudgeon pins |
|
| Author: | Scrawny [ Wed Oct 21, 2009 10:38 pm ] |
| Post subject: | Re: tapin noise |
Noises are sometimes hard to track down. I would start with adjusting tappets as suggested then go from there |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|