auszookers.com
https://www.auszookers.com/forum/

removal of speedo gear from sierra Tcase
https://www.auszookers.com/forum/viewtopic.php?f=5&t=6908		 Page 1 of 1
Author:  lump_a_charcoal [ Mon Sep 28, 2009 10:56 pm ]
Post subject:  removal of speedo gear from sierra Tcase
Halp!

I cannot get the speedo gear unit out of the transfer case, I think the gear is a bit munted as the main cluster turns, but the gear shaft doesn't....

I removed the retaining screw, but no matter how tight I grip the sleeve, I cannot get it to budge. I have already had one case destroyed, I don't need another fucked.

I have access to bugger all equipment, but may have some gear at work that I can use...
Author:  steak_knife [ Mon Sep 28, 2009 11:25 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
The little tag the retainer goes through, give it a lil TAP with a hammer side way`s, you want to turn it not snap it. That should loosen the o`ring seal up. If you can get it to turn, get the tag so you can get a screw driver under it 7 again TAP upwards.

Hope that help`s
Author:  jimbo_jones [ Mon Sep 28, 2009 11:26 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
yep that should work steking
Author:  steak_knife [ Mon Sep 28, 2009 11:31 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
jimbo_jones wrote:
yep that should work steking



Just had a thort tho, is there a tag? or dose the bolt go through the drive?
I spend to much time on new shit box`s.
Author:  Built4thrashing [ Mon Sep 28, 2009 11:50 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
the retaining bolt goes through the sleeve and locks into a recess on the cable. Pull the bolt all the way out and try to twist the sleeve. if it twists then it should come out.
i just rebuilt another t/case and had trouble getting the speedo drive out as it was stuck in wih silicone. gave it a twist and pulled at the same time and it came out that fast i smacked myself in the mouth.

B4T
Author:  Damo [ Tue Sep 29, 2009 1:49 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Built4thrashing wrote:
the retaining bolt goes through the sleeve and locks into a recess on the cable. Pull the bolt all the way out and try to twist the sleeve. if it twists then it should come out.
i just rebuilt another t/case and had trouble getting the speedo drive out as it was stuck in wih silicone. gave it a twist and pulled at the same time and it came out that fast i smacked myself in the mouth.

B4T


:lol:

Have done things similar once or twice. Luckily no one else is usually around!
Author:  lump_a_charcoal [ Tue Sep 29, 2009 2:08 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Yeah this one is stuck fast - any ideas anyone?
Author:  steak_knife [ Tue Sep 29, 2009 2:11 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
lump_a_charcoal wrote:
Yeah this one is stuck fast - any ideas anyone?


Vice grip`s & turn the Tap into a Hit...
Author:  303zuke [ Tue Sep 29, 2009 3:07 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Built4thrashing wrote:
i just rebuilt another t/case and had trouble getting the speedo drive out as it was stuck in wih silicone. gave it a twist and pulled at the same time and it came out that fast i smacked myself in the mouth.

B4T

Is that up on Youtube? I'd like to see that.
Author:  Taff [ Tue Sep 29, 2009 3:14 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
vice grips worked on mine. dont try and pull it just twist it first
Author:  Hybrid [ Tue Sep 29, 2009 11:35 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
This might be completely retarded as its been years since I rebuilt my case but could you get compressed air in their to help push while you pull?
Author:  lump_a_charcoal [ Tue Sep 29, 2009 11:46 am ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Prob not, can't get to the other side...

Would some heat help, or is that a no no with alloy?
Author:  lump_a_charcoal [ Tue Sep 29, 2009 1:34 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Well I got it out finally- turned it using vice grips, with a shifter on those. heaps of fox piss, then tapped the vice grips with a hammer, and out she popped.
No visible damage either - weird!
Author:  v.w.dave [ Tue Sep 29, 2009 3:31 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Hi mate good to see you got it out in the end.
I put rockhoppers in mine last weekend. Mine was as hard to get out. I ended up using a bench press to press the outputshaft out. I did thid very very slowly. I could see the speedo was spinning. I did the save to put the shaft back in. It was very risky but it worked. I have driven it for 4 days now ans it is working soo this mite be a last resort for anyone next time.
Just go slow and be carefull.
Author:  Built4thrashing [ Tue Sep 29, 2009 11:16 pm ]
Post subject:  Re: removal of speedo gear from sierra Tcase
Thankfully nobody else was there to see it. but fuck it hurt.

B4T
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/