| auszookers.com https://www.auszookers.com/forum/ |
|
| 1.6 sump ok? https://www.auszookers.com/forum/viewtopic.php?f=5&t=6743 |
Page 1 of 1 |
| Author: | jakeyr [ Sun Sep 20, 2009 6:04 am ] |
| Post subject: | 1.6 sump ok? |
just wondering i am about to do an engine conversion putting a 1.6 carby in my sierra i have heard you need to put the 1.3 sump on the 1.6 because there isn't enough clearance, i have a spoa lift do you think i will be able to fit the 1.6 sump or will i still need to change them over? |
|
| Author: | Gwagensteve [ Sun Sep 20, 2009 11:45 am ] |
| Post subject: | Re: 1.6 sump ok? |
That depends a bit on how your SPOA is set up, but there's normally plenty of room to use the 1.6 sump. I've seen some very low and unbumpstopped spoa's with 1.6 sumps. Steve. |
|
| Author: | shep [ Sun Sep 20, 2009 1:24 pm ] |
| Post subject: | Re: 1.6 sump ok? |
i have a spring under SWB with a 1.6 and have no problems with sump clearance however i have moved my diff forward a fair bit. it only has 25mm bumpstops as well |
|
| Author: | jakeyr [ Sun Sep 20, 2009 9:36 pm ] |
| Post subject: | Re: 1.6 sump ok? |
if i do need to change the sump is it a stright swap over |
|
| Author: | shep [ Sun Sep 20, 2009 10:06 pm ] |
| Post subject: | Re: 1.6 sump ok? |
jakeyr wrote: if i do need to change the sump is it a stright swap over
sump yes. oil pickup no. |
|
| Author: | Gwagensteve [ Sun Sep 20, 2009 11:06 pm ] |
| Post subject: | Re: 1.6 sump ok? |
There's cutting and welding involved in swapping the oil pickup over. Good point shep - RUF, for instance, helps a lot. Steve. |
|
| Author: | jakeyr [ Mon Sep 21, 2009 1:07 am ] |
| Post subject: | Re: 1.6 sump ok? |
is there any info on how to swap the oil pickup over or could someone give me a run down |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|