Should there be another dowel in the top of the block at the rear?
If there is where do I get one from as it gone AWOL?
Could have been one of those Bots.
| auszookers.com https://www.auszookers.com/forum/ |
|
| Head Dowel https://www.auszookers.com/forum/viewtopic.php?f=5&t=6721 |
Page 1 of 1 |
| Author: | DMAC [ Fri Sep 18, 2009 10:57 pm ] |
| Post subject: | Head Dowel |
Should there be another dowel in the top of the block at the rear?
If there is where do I get one from as it gone AWOL?
Could have been one of those Bots.
|
|
| Author: | Rusho [ Fri Sep 18, 2009 11:00 pm ] |
| Post subject: | Re: Head Dowel |
Yes there should...Don't know. Its only for alignment of the head isn't it?? Better get it fixed, you got a month till the next big outing!! |
|
| Author: | zooker [ Fri Sep 18, 2009 11:05 pm ] |
| Post subject: | Re: Head Dowel |
check in the bottom of the head  Thats where mine was last time I took it off
|
|
| Author: | DMAC [ Fri Sep 18, 2009 11:07 pm ] |
| Post subject: | Re: Head Dowel |
Yep I sorta figured there should be one there. Can't for the life of me remember there being one there when I took it off. Finished swapping the cam and rockers over this arvo. Ready to throw the head on and umm that doesn't look right. You recon Bursons would have one? |
|
| Author: | DMAC [ Fri Sep 18, 2009 11:09 pm ] |
| Post subject: | Re: Head Dowel |
zooker wrote: check in the bottom of the head
Thats where mine was last time I took it off I went and had a big boy look and yep in the bottom of the old head.
Thanks Zooker. 
|
|
| Author: | Built4thrashing [ Fri Sep 18, 2009 11:14 pm ] |
| Post subject: | Re: Head Dowel |
I was missing both mine on a head that got reco'd so we just cut some short bits of 1/2 inch copper waterpipe and used them. exact same size and were a neat fit too. B4T |
|
| Author: | Rusho [ Fri Sep 18, 2009 11:21 pm ] |
| Post subject: | Re: Head Dowel |
DMAC wrote: zooker wrote: check in the bottom of the head Thats where mine was last time I took it off I went and had a big boy look and yep in the bottom of the old head. Thanks Zooker. HeHeHeHe Don't you hate that? 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|