| auszookers.com https://www.auszookers.com/forum/ |
|
| Sierra tie rod end taper https://www.auszookers.com/forum/viewtopic.php?f=5&t=57458 |
Page 1 of 1 |
| Author: | shep [ Sun Feb 05, 2023 8:21 pm ] |
| Post subject: | Sierra tie rod end taper |
I need to make this bit fit a Sierra tie rod end, does anyone know what the taper is so I can order the right reamer? Attachment: 8103175B-3E46-47F9-A16E-293FCF037818.jpeg
|
|
| Author: | Brenno [ Mon Feb 06, 2023 4:17 am ] |
| Post subject: | Re: Sierra tie rod end taper |
https://www.yotamasters.com/shop/knuckl ... er-reamer/ 1:10 it looks like? |
|
| Author: | shep [ Thu Mar 16, 2023 2:54 pm ] |
| Post subject: | Re: Sierra tie rod end taper |
1:10 looks like being the right one, thanks Brenno $20 on eBay and I am closer to driving my LJ |
|
| Author: | fordem [ Fri Mar 17, 2023 12:23 am ] |
| Post subject: | Re: Sierra tie rod end taper |
Brenno wrote: https://www.yotamasters.com/shop/knuckle-service-upgrades/tools-misc/taper-reamer/ 1:10 it looks like? Nope - that tool is used to ream out the Suzuki pitman arm to accept an FJ80 TRE, the FJ80 is 1:10 taper, the Suzuki is different |
|
| Author: | Brenno [ Fri Mar 17, 2023 10:21 am ] |
| Post subject: | Re: Sierra tie rod end taper |
I was told by Coliso that 80 and sierra are the same taper hence why his arms with 80 TRE fit Sierra knuckles |
|
| Author: | shep [ Fri Mar 17, 2023 2:26 pm ] |
| Post subject: | Re: Sierra tie rod end taper |
Sierra must be 1:10 because after I resized the LJ taper the Sierra tie rod fits perfectly. The difference may just be the size of the hole |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|