auszookers.com
https://www.auszookers.com/forum/

Need help identifying denso box out of 98 jimny
https://www.auszookers.com/forum/viewtopic.php?f=5&t=44623		 Page 1 of 1
Author:  sam_516 [ Fri Jan 10, 2014 2:44 pm ]
Post subject:  Need help identifying denso box out of 98 jimny
Dropped a new engine in my jimny after a water induced over heating issue

Now every time I try to crank it over it pops a fuse straight away,
Got the auto sparky out and he said the short is in this denso box

Image
<a href="http://s136.photobucket.com/user/sam_516/media/Mobile%20Uploads/9079BDC5-481B-43AA-A931-30153FFCED61.jpg.html" target="_blank"><img src="http://i136.photobucket.com/albums/q162/sam_516/Mobile%20Uploads/9079BDC5-481B-43AA-A931-30153FFCED61.jpg" border="0" alt=" photo 9079BDC5-481B-43AA-A931-30153FFCED61.jpg"/></a>

He wasn't sure what it is for so befor I buy a new one and get him back out just want to be able to tell him what it is for
Author:  tanshi [ Fri Jan 10, 2014 2:54 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
google says, HVAC Control Module
Author:  tanshi [ Fri Jan 10, 2014 2:55 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
and before you ask, google says hvac means Heating, Ventilation and Air Conditioning
Author:  sam_516 [ Fri Jan 10, 2014 3:31 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
So since It shouldn't be stopping the engine from starting then?
Author:  sam_516 [ Fri Jan 10, 2014 3:32 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
Guessing that that is the burning smell I got ages ago last time I used the aircon
Author:  tanshi [ Fri Jan 10, 2014 3:59 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
depends if the ecu looks to it for a signal for any thing.
Author:  sam_516 [ Fri Jan 10, 2014 4:30 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
Just found a wiring diagram and the fuse that keeps blowin is the windscreen wipers...
I have no radio and no check engine light
The relays are clicking when I turn the key on and the starter motor clicks but won't actually crank, the battery is 100% full only just pulled it off the charger...

I'm lost
Author:  tanshi [ Fri Jan 10, 2014 4:33 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
why are you lost. if the issue is in the hvac box get the hvac box fixed.
Author:  sam_516 [ Fri Jan 10, 2014 4:44 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
If it burnt out when the a/c stopped working that was ages ago and was running with it blown, and it runs on a separate circuit to the ignition/radio

I'm going to replace the havc just to rule it out but I rang the auto electrition and he said it shouldn't stop it from turning over
Author:  tanshi [ Fri Jan 10, 2014 4:47 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
I agree, but then if its not caused by the Hvac the auto elec should be able to tell you what is causing the issue
Author:  kenn [ Sun Jan 12, 2014 6:34 am ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
Ahh mud! It kills everything. Did you try a new starter in it ?
Oh and I'd get a better sparky. :)
Author:  whincup [ Sun Jan 12, 2014 7:15 am ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
if the starter motor clicks but doesnt crank wouldnt that be an issue with the starter motor?
Author:  zukenutter [ Wed Jan 15, 2014 2:34 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
Try clutch starting it
Author:  Jezza86 [ Wed Jan 15, 2014 2:55 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
zukenutter wrote:
Try clutch starting it

push starting?
have you tapped the starter yet? sometimes they get deadspots where they cant produce enough initial torque to get momentum and inertia required to start the car. giving it a tap with a hammer sometimes works.
extreme case is roll starting in 2nd, and trying to start the car at the same time you dump the clutch. ive seen this work just have to make sure you dont overrun the starter if it works for you

lowndsey did this one year in the v8's. lost his clutch so had to start the car in 1st and use the startermotor to drive the car forward till the engine kicked over, cos your tyres cant be spinning when you on the airjacks so he had to turn the car off while they were refueling and jacked.
Author:  Scrawny [ Wed Jan 15, 2014 4:39 pm ]
Post subject:  Re: Need help identifying denso box out of 98 jimny
Are the connections tight on pos and neg cables?
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/