Joined: Mon Aug 05, 2013 8:24 pm Posts: 36
Vehicle: sj50 sierra
Posted: Sun Aug 25, 2013 9:45 pm
hey everyone, not sure if I'm in the right spot or not but anyways.. I have a sj50 sierra which I've just done a g13b engine conversion on.. I have lost the reds on my dash and can't figure out why.. they were working before and after the conversion until today when I went to start it, car still starts off the key and everything but it just won't give me reds.. all I remember doing was removing the battery to put it on charge! any help would be much appreciated
Joined: Sun Aug 16, 2009 11:30 pm Posts: 1409 Location: Newcastle NSW
Vehicle: '96 LWB trayback
Posted: Mon Aug 26, 2013 6:25 pm
Fusible link is basically a meltable wire on the main positive supply right at the battery terminal. In between the positive terminal and the white plug 6inches away, sheathed in black burn proof materlal.
Joined: Mon Aug 05, 2013 8:24 pm Posts: 36
Vehicle: sj50 sierra
Posted: Thu Aug 29, 2013 5:42 am
car isn't actually running at the moment so couldn't tell you the charge until I finish my fuel system.. all I know was that they were working after I had done the conversion but then have now just stopped.. gone over absolutely everything that I've touched and can't find it..
Users browsing this forum: No registered users and 61 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum