| auszookers.com https://www.auszookers.com/forum/ |
|
| XL7's driveline differences to GV https://www.auszookers.com/forum/viewtopic.php?f=5&t=41785 |
Page 1 of 1 |
| Author: | Built4thrashing [ Sun Jul 07, 2013 4:28 pm ] |
| Post subject: | XL7's driveline differences to GV |
Can anyone shed any light as to the differenced in the XL7 driveline as against the GV's. What are the diff ratios? Axle spline in the rear diff...26 or 28 spline? Are there any major differences Cheers |
|
| Author: | got_bar_work [ Sun Jul 07, 2013 4:36 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
The rear center is bigger and axels are much bigger i think The later ones ran 5 speed auto |
|
| Author: | atari4x4 [ Sun Jul 07, 2013 6:20 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
centre bearing on the rear 2 piece shaft |
|
| Author: | Built4thrashing [ Sun Jul 07, 2013 6:46 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
What about diff ratios? Are they 4.3, 4.6, 4.8 or 5.12 |
|
| Author: | atari4x4 [ Sun Jul 07, 2013 6:56 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
turn the flange on the front diff 1 full rotation & count the turns of the LHS? |
|
| Author: | Built4thrashing [ Sun Jul 07, 2013 9:49 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
atari4x4 wrote: turn the flange on the front diff 1 full rotation & count the turns of the LHS? But that involves getting off my ass and getting dirty..... again. |
|
| Author: | ninjamoses [ Sun Jul 07, 2013 9:52 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
Sounds like they will be 5.12 from what I could find on google. |
|
| Author: | atari4x4 [ Sun Jul 07, 2013 9:53 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
true that, there is a diiff ratio thread, but not sure if it lists XLimo-7's |
|
| Author: | alexxx [ Sun Jul 07, 2013 10:05 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
ill buy them if they are 5.12 |
|
| Author: | Built4thrashing [ Sun Jul 07, 2013 10:11 pm ] |
| Post subject: | Re: XL7's driveline differences to GV |
I'm wondering if its worthwhile getting the rear centre out if its a 5.15. I know axles are different but what about the rest? will the XL7 centre bolt into a GV housing? Too many unknowns.... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|