| auszookers.com https://www.auszookers.com/forum/ |
|
| Fitting an air locker, replace what parts? https://www.auszookers.com/forum/viewtopic.php?f=5&t=41022 |
Page 1 of 1 |
| Author: | klutched [ Tue May 21, 2013 1:11 pm ] |
| Post subject: | Fitting an air locker, replace what parts? |
Ok, so I'm getting my air locker fitted up front in a week or two. Just want to know what I should replace while I'm doing it? I have new oil seals both sides and a pinion oil seal as well. Anything else I should get ? Gideon |
|
| Author: | tanshi [ Tue May 21, 2013 1:20 pm ] |
| Post subject: | Re: Fitting an air locker, replace what parts? |
you will need a new crush tube if your doing a pinion seal. i personally would do the pinion and carrier bearings while your in there. |
|
| Author: | mrw82 [ Tue May 21, 2013 5:06 pm ] |
| Post subject: | Re: Fitting an air locker, replace what parts? |
Agree with tanshi that replacing bearings is the 'proper' way to do it. but a locker CAN be fitted without touching the pinion (gear, bearings, seal and crush tube). |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|