auszookers.com
https://www.auszookers.com/forum/

replacing cv shafts in vitara estate
https://www.auszookers.com/forum/viewtopic.php?f=5&t=37981		 Page 1 of 1
Author:  tsock0 [ Sat Dec 29, 2012 7:18 pm ]
Post subject:  replacing cv shafts in vitara estate
ay fellaz,

just wondering if anyone here has a step by step procedur on replacing the complete cv shafts in a 93 mod lwb vitara estate

i had a seach but couldnt find much

cheers pompoms
Author:  christover1 [ Sat Dec 29, 2012 8:05 pm ]
Post subject:  Re: replacing cv shafts in vitara estate
Left comes out easily.
Remove free wheel hub, when in free position.
remove circlip on end of shaft.
Undo 3 nuts on flange near diff.
It slides out, with a mild bit of jiggling.

Right is harder, as it has a shaft into diff,
this side needs some suspension loosening, removal of sway bar, to get enough room to remove.
Depends on set up how much comes off.
Some need to drop brake lone bracket off the strut
Author:  tsock0 [ Sat Jan 05, 2013 3:24 pm ]
Post subject:  Re: replacing cv shafts in vitara estate
thanks for the help

all in and sorted

worst part was actually fitting the new drivers side cv as the ring around the spline was too wide not allowing it to push right in , i just swapped the new clip with the original

also all i did was dropped the complete hub off and it slid straight out..........alright with a little swaering and jiggling

thanks again another job done
Author:  christover1 [ Sat Jan 05, 2013 3:44 pm ]
Post subject:  Re: replacing cv shafts in vitara estate
You do realise rthat the to do lists only ever get longer, never shorter :)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/