| auszookers.com https://www.auszookers.com/forum/ |
|
| cnc cutting brakes how to plumb them in? https://www.auszookers.com/forum/viewtopic.php?f=5&t=34034 |
Page 1 of 1 |
| Author: | Ridge [ Tue Jul 10, 2012 2:35 pm ] |
| Post subject: | cnc cutting brakes how to plumb them in? |
Im looking into cutting brakes, but i have not come across on any info to plumb them in. I will be using them on the rear diff and ill be running gq discs and subaru calipers. I know that i will need to get them with a 3/4" bore size due to the discs. Here is what im looking at http://www.racereadyproducts.com/cnc-cu ... al-handle/ Anyone have experience with this stuff? |
|
| Author: | Red89 [ Tue Jul 10, 2012 5:31 pm ] |
| Post subject: | Re: cnc cutting brakes how to plumb them in? |
I just run all new lines from the master cylinder into the cab then back out to the diff. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|