auszookers.com
https://www.auszookers.com/forum/

How to get a CV off axle?
https://www.auszookers.com/forum/viewtopic.php?f=5&t=32010		 Page 1 of 1
Author:  suzukikid [ Sun Apr 22, 2012 11:12 am ]
Post subject:  How to get a CV off axle?
i have a few short sides here and a long side with a broken cv.... how do i get one off one onto the other?

apparentky ya just hit em off.... but i cant get it too work! :roll:
Author:  want33s [ Sun Apr 22, 2012 11:19 am ]
Post subject:  Re: how to get a cv off?
There are a couple of ways to do it..
Be prepared though as it will prob be a waste of time...
Most times when you remove the CV it damages the end of the axle where the CV clip locks on and cannot be reused.

This is how I do it but with a vise instead of tube.
http://www.youtube.com/watch?v=S0_jL83jMH8

Make sure you tape up the seal seat on the axle so you don't damage it.
Author:  boostedbrick [ Sun Apr 22, 2012 2:56 pm ]
Post subject:  Re: how to get a cv off?
I've found every time I have removed a broken CV from a good looking shaft, that the spline has been damaged when the cv let go. But worth a shot anyway, I use the trick posted above and it works most times.
Author:  suzukikid [ Sun Apr 22, 2012 6:05 pm ]
Post subject:  Re: how to get a cv off?
cheers boys!

got the short side off easy as...had hack the brokin one off with a grinder!!!!!

the spline is fine...this broke really weird....broke the spline off in the hub and took the hub with it!....
Author:  SierraDan [ Sun Apr 22, 2012 6:18 pm ]
Post subject:  Re: how to get a cv off?
Would hilux CV's handle that method better?
Author:  want33s [ Mon Apr 23, 2012 7:47 am ]
Post subject:  Re: how to get a cv off?
Hilux's don't usually break the end of the shaft, they just snap the lock ring like happened in the video above.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/