[sideways]

Yeah, yeah, I know, shifter bush.

Given this is a 1981 SJ40 with a non-switch case, will the bush from a switched case fit?

Could it be anything else? At the time I was fixing a transfer mount and pulling the front tail shaft out, from underneath I changed it from low 4 to neutral so I could turn the shaft then I got distractracted and went off to do something else. When I came back I found it was stuck in neutral. You can move the stick in a 20mm square and that's it. Force or rocking or forwards/reverse input from the gear box wont move it.

I have not yet tried to pull the stick out and change gears with a screwdriver ect.

Bloody car, I had a trip planned for today.

Thanks

Hayden

[want33s]

Try lifting the stick a bit before trying to shift.

[sideways]

Tried that, nothing. :/

I've tried just about everything in terms of stick positioning.

Will the bush from a switched case fit a non switch case?

Also, I need the boot that goes on the case, will a switched one fit?

[want33s]

sideways wrote:

Tried that, nothing. :/

I've tried just about everything in terms of stick positioning.

Will the bush from a switched case fit a non switch case?

Also, I need the boot that goes on the case, will a switched one fit?

The rubber boot is same same but I'm not sure about the shifter sheet.