Hahaha Mark
Cheers Zook_Fan - ah well, worth asking.
| auszookers.com https://www.auszookers.com/forum/ |
|
| Plastic 1L dash into metal 1L dash body? https://www.auszookers.com/forum/viewtopic.php?f=5&t=30414 |
Page 1 of 1 |
| Author: | scorpydude [ Mon Feb 13, 2012 9:56 am ] |
| Post subject: | Plastic 1L dash into metal 1L dash body? |
Does anyone know if a plastic 1L dash (with the 'oh shit' handle on passenger side) would bolt directly into a 1L body that came with a metal dash without the 'oh shit' handle? At the moment I have a '84 SJ40 (1L) with a metal dash and pretty much every single one of the heater box and air sliders etc behind the center console is broken. I was going to replace it all then though I might as well upgrade to the nicer plastic dash while i'm at it. Thanks. |
|
| Author: | mrw82 [ Mon Feb 13, 2012 10:23 am ] |
| Post subject: | Re: Plastic 1L dash into metal 1L dash body? |
You have an oh shit handle, it's also commonly referred to as a steering wheel. Don't worry about one for the passanger. They should be holding the camera. |
|
| Author: | Zook_Fan [ Mon Feb 13, 2012 10:28 am ] |
| Post subject: | Re: Plastic 1L dash into metal 1L dash body? |
Each to their own but I think the metal dashes are way better. They leave heaps more room in the cab. However if you do want to do it, it can be done but it's not a bolt in job. |
|
| Author: | scorpydude [ Mon Feb 13, 2012 10:34 am ] |
| Post subject: | Re: Plastic 1L dash into metal 1L dash body? |
Hahaha Mark Cheers Zook_Fan - ah well, worth asking. |
|
| Author: | Zook_Fan [ Mon Feb 13, 2012 10:46 am ] |
| Post subject: | Re: Plastic 1L dash into metal 1L dash body? |
And some may consider worth doing. There is a blue ute build up in the rigs section that showed a few pics of the swap. Think it was an 81 or 82 if that helps with searching. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|