| auszookers.com https://www.auszookers.com/forum/ |
|
| G16B Airconditioning loom - where does this wire go? https://www.auszookers.com/forum/viewtopic.php?f=5&t=30393 |
Page 1 of 1 |
| Author: | Oldmate28 [ Sun Feb 12, 2012 2:43 pm ] |
| Post subject: | G16B Airconditioning loom - where does this wire go? |
Hi everyone I was lucky enough to buy the full air conditioning setup from a fellow Auszooker member and have just finished installing it, however I have come down to a single wire in the engine bay and cannot work out where to connect it. The loom for the air conditioning has the end with all of the relays and there is a fat red cable which must connect to the battery, on the same end of the loom there is a skinny single wire which is yellow with a blue trace... mine has a small female spade connector on it. Where does it go? We are thinking it may connect to the thermostat on the motor but may be wrong. If it does do we splice it with te existing wore to the thermostat? Can someone please have a look under their bonnet and let me know? and possible provide a photo? There is an earth wire there which we have hooked up so it must be for something else.. Thank you! |
|
| Author: | christover1 [ Sun Feb 12, 2012 4:19 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
Sounds like the wire to the second sender on rear side of themostat. It is a overheat cut out sender, it turns off ac and runs the condenser fan only, if engine is too hot. I go check mine, shortly, see what colur it is/was (I by passed mine with a switch, so I can run the fan when crawling) |
|
| Author: | christover1 [ Sun Feb 12, 2012 4:31 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
It is a different type of sender, you can't use the normal temp sender at the front of thermostat housing. |
|
| Author: | christover1 [ Sun Feb 12, 2012 4:32 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
Can't see original wiring in mine, so I lookin at a diagram, see if I can work out colors. |
|
| Author: | christover1 [ Sun Feb 12, 2012 4:55 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
I'm pretty sure if you earth it, fan will come on, that will tell yo |
|
| Author: | Oldmate28 [ Sun Feb 12, 2012 4:57 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
No worries, thanks for your help. I might earth it and see what happens. |
|
| Author: | royce [ Sun Feb 12, 2012 5:18 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
is it factory air or aftermarket? |
|
| Author: | Oldmate28 [ Sun Feb 12, 2012 5:31 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
It's factory. I can see a bolt plugging a hole on the outer side of the thermostat just above a electrical plug, maybe there is a temp sensor to be mounted in that hole? |
|
| Author: | christover1 [ Sun Feb 12, 2012 5:34 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
http://www.wiringdiagrams21.com/2010/02 ... ng-diagram This may help |
|
| Author: | royce [ Sun Feb 12, 2012 5:34 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
how long is it? I am thinking it probably interfaces with the factory loom somewhere sure its factory air? I always thought all the relays and stuff all happened behind the glovebox |
|
| Author: | christover1 [ Sun Feb 12, 2012 5:37 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
Oldmate28 wrote: It's factory. I can see a bolt plugging a hole on the outer side of the thermostat just above a electrical plug, maybe there is a temp sensor to be mounted in that hole? Yes a sender can go in there. Supercheap have both senders, so they should be available in real auto shops. yellow and blue is a sender wire according to that info |
|
| Author: | royce [ Sun Feb 12, 2012 5:41 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
yep Christover has it, checked the factory diagrams and its a temp switch, earths out for too hot likely you could happily go on without hooking it to anything |
|
| Author: | Oldmate28 [ Sun Feb 12, 2012 5:44 pm ] |
| Post subject: | Re: G16B Airconditioning loom - where does this wire go? |
Sweet, thanks guys. I will chase down a new sensor and get it up and running. Appreciate your help. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|