| auszookers.com https://www.auszookers.com/forum/ |
|
| 4wd light switch https://www.auszookers.com/forum/viewtopic.php?f=5&t=26966 |
Page 1 of 1 |
| Author: | 607CHA [ Thu Oct 20, 2011 6:41 pm ] |
| Post subject: | 4wd light switch |
Put my 6.5 gear set in and with all the moving around i snapped off one of the wires for the 4wd light switch. 2 questions. can it be taken out without dropping the oil and if can would it be better yo buy a new one or try and solder the one i got |
|
| Author: | tonyevans [ Thu Oct 20, 2011 7:41 pm ] |
| Post subject: | Re: 4wd light switch |
New ones are cheep and its hard to keep moisture out after soldering. |
|
| Author: | want33s [ Thu Oct 20, 2011 8:06 pm ] |
| Post subject: | Re: 4wd light switch |
The wire is most likely broken where it goes into the resin on top of the switch leaving nothiong to solder the wire back onto. www.suzistore.com.au sell new switches for NT or WT for about $35 delivered I think. |
|
| Author: | SierraDan [ Thu Oct 20, 2011 11:25 pm ] |
| Post subject: | Re: 4wd light switch |
and dont need to drop the oil. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|