auszookers.com
https://www.auszookers.com/forum/

SV420 Rear Drive Shaft Uni Joints
https://www.auszookers.com/forum/viewtopic.php?f=5&t=26908		 Page 1 of 1
Author:  atari4x4 [ Wed Oct 19, 2011 3:56 am ]
Post subject:  SV420 Rear Drive Shaft Uni Joints
:helloo: AZ Crew.

Anyone know the part numbers for both of the uni joints in the rear drive shaft of a SV420 & if they are the same as the SE416?

Cheers
Gus
Author:  atari4x4 [ Wed Oct 19, 2011 4:14 am ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
Found this on the Hardy Spicer pdf catalogue, WTF are staked joints?

VITARA

SWB 1.6L 1988 on K5-A557 K5-A557 FRONT & REAR SHAFT
LWB 1.6L 1991 on K5-A557 K5-A557 FRONT & REAR SHAFT
LWB V6 1995 on STAKED JOINTS VEHICLES HAVE STAKED JOINTS (UNSERVICEABLE WITHOUT SPECIAL TOOLING)REFER HARDY SPICER
Author:  weaves [ Wed Oct 19, 2011 4:27 am ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
staked means they dont have circlips. You actually use a pin punch to distort the metal over the ends to hold it in. (300zx's have the same)

And you will need a dremel to get them out.

But that isnt what you have, yours being a SWB has the K5-A557. Which have plain ends, that take circlips.

so you should be sweet.
Author:  atari4x4 [ Wed Oct 19, 2011 4:28 am ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
thanks weaves, pretty sure mine have circlips... but will have to check. :?
Author:  weaves [ Wed Oct 19, 2011 4:30 am ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
i obviously edited that while you replied
Author:  atari4x4 [ Wed Oct 19, 2011 4:33 am ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
8)
Author:  atari4x4 [ Wed Oct 19, 2011 9:56 pm ]
Post subject:  Re: SV420 Rear Drive Shaft Uni Joints
Ordered 2 Hardy Spicer Uni Joints, $34 each + $10 for an overnight bag. 8)

Repco don't even have a listing for them. :roll:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/