Is it just me, or does that first picture look like your jimny is shouting at you?
| auszookers.com https://www.auszookers.com/forum/ |
|
| seat mounnts on a jimny https://www.auszookers.com/forum/viewtopic.php?f=5&t=22261 |
Page 1 of 1 |
| Author: | DSKEW3 [ Wed May 25, 2011 3:31 am ] |
| Post subject: | seat mounnts on a jimny |
ohhhhhhh S**T i just broke 2 seat mounts on my 99' jimny wat can i do?? |
|
| Author: | tanshi [ Wed May 25, 2011 3:35 am ] |
| Post subject: | Re: seat mounnts on a jimny |
mate were gonna need pics or a much better description of what you have broken before we can help. |
|
| Author: | DSKEW3 [ Wed May 25, 2011 3:42 am ] |
| Post subject: | Re: seat mounnts on a jimny |
the pics i have got are to big so iam trying to make them smaller |
|
| Author: | DSKEW3 [ Wed May 25, 2011 3:52 am ] |
| Post subject: | Re: seat mounnts on a jimny |
here are some pics |
|
| Author: | DSKEW3 [ Wed May 25, 2011 4:43 am ] |
| Post subject: | Re: seat mounnts on a jimny |
just found that some of the others are cracked will welding then be strong enough?? |
|
| Author: | squibby [ Wed May 25, 2011 4:57 am ] |
| Post subject: | Re: seat mounnts on a jimny |
Is it just me, or does that first picture look like your jimny is shouting at you?
|
|
| Author: | squibby [ Wed May 25, 2011 5:06 am ] |
| Post subject: | Re: seat mounnts on a jimny |
I think your jimny is fooked. Faulty Seat mounts are going to fail any road worthy inspection if the assessor sees it. You are going to have to get a very good job done to fix it. If I was you I'd get it fixed at the same garage you intend to have future road-worthiness assessments done, and keep the receipt so you know they will always pass your vehicle since they repaired it. If they see someone elses welding or repairs around the seat mounts they are going to be very strict. A couple of my vehicles used to fail if there was any rust near the seat mount until I had a plate welded over the affected areas. And that was in europe where assessors are far more forgiving of rust, all cars are rusty. In australia my experience so far is that the garages and car owners in general get the shits at the first signs of a bit of surface rust, seats mounts rusting off has got to be bad. |
|
| Author: | BertZook [ Wed May 25, 2011 6:22 am ] |
| Post subject: | Re: seat mounnts on a jimny |
squibby wrote: Is it just me, or does that first picture look like your jimny is shouting at you?
|
|
| Author: | Fatzook [ Wed May 25, 2011 9:17 am ] |
| Post subject: | Re: seat mounnts on a jimny |
I can fix that quite easily. I'm in Brisbane, so If you travel down here at all I could get it done for you. Garanteed to pass RWC too. 
|
|
| Author: | DSKEW3 [ Thu May 26, 2011 12:13 am ] |
| Post subject: | Re: seat mounnts on a jimny |
HOW MUCH MATE?? |
|
| Author: | Benz [ Thu May 26, 2011 11:54 am ] |
| Post subject: | Re: seat mounnts on a jimny |
how did you manage to do that :S |
|
| Author: | smiffkid [ Thu May 26, 2011 12:01 pm ] |
| Post subject: | Re: seat mounnts on a jimny |
mine was like that, when i changed to stratos seats we noticed it, so we cut the floor out and welded some square sheet in there, then braced in under neath |
|
| Author: | Fatzook [ Thu May 26, 2011 12:05 pm ] |
| Post subject: | Re: seat mounnts on a jimny |
DSKEW3 wrote: HOW MUCH MATE??
NFI. Call me tomorrow. Peter 0404 057 383 |
|
| Author: | doish [ Thu May 26, 2011 12:24 pm ] |
| Post subject: | Re: seat mounnts on a jimny |
squibby wrote: Is it just me, or does that first picture look like your jimny is shouting at you?
actually made me choke on my drink
|
|
| Author: | DSKEW3 [ Sun May 29, 2011 6:58 am ] |
| Post subject: | Re: seat mounnts on a jimny |
here are the measurements of the mounts |
|
| Author: | DSKEW3 [ Sun May 29, 2011 7:21 am ] |
| Post subject: | Re: seat mounnts on a jimny |
and also there are 2 cracks on the drivers side rear mounts. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|