auszookers.com • View topic - Drag link project

Board index » Talking About Stuff » Suzuki Talk

Drag link project

Page 1 of 1

[ 6 posts ]

Print view

Previous topic | Next topic

Author

Message

burls

az supporter

Joined: Sun Mar 07, 2010 10:30 pm
Posts: 989
Location: Ipswich
Vehicle: 95 sj70 and 78 lj81

Posted: Tue May 10, 2011 10:08 am

Can I get a measurement from bolt centre to bolt centre of a drag link for a 95 sj70 or compatible. I'll load up story after its finished. Measurement from separate sources would be good to ensure accuracy

burls

az supporter

Joined: Sun Mar 07, 2010 10:30 pm
Posts: 989
Location: Ipswich
Vehicle: 95 sj70 and 78 lj81

Posted: Mon May 16, 2011 9:34 am

Bump
anyone handy with a tape measure and a sj70 zook with a straight drag link could do this for me. please

steak_knife

az supporter

Joined: Fri May 22, 2009 11:30 pm
Posts: 21335
Location: Smart Ass Island

Posted: Mon May 16, 2011 12:37 pm

burls wrote:

Can I get a measurement from bolt centre to bolt centre of a drag link for a 95 sj70 or compatible. I'll load up story after its finished. Measurement from separate sources would be good to ensure accuracy

if your talking tie rod "bolt center", it will be different from car to car, as this will change with wheel alinement...

_________________
I used to be indecisive,
now I'm not so sure.....

burls

az supporter

Joined: Sun Mar 07, 2010 10:30 pm
Posts: 989
Location: Ipswich
Vehicle: 95 sj70 and 78 lj81

Posted: Mon May 16, 2011 9:40 pm

Thanks for that but what I really want is the length of a straight Draglink from bolt centre to eye centre

zooky08

az supporter

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Posted: Mon May 16, 2011 10:59 pm

Bolt to bolt is the tie rod
That's what u said first
So you want the measurements for the drag link which goes from steering box to tie rod

If you can hold on until this arvo I can get a rough measurement
Mines out of the car ATM

_________________
03 Jimny 30 km2s 75mm lift f&r locked winch

burls

az supporter

Joined: Sun Mar 07, 2010 10:30 pm
Posts: 989
Location: Ipswich
Vehicle: 95 sj70 and 78 lj81

Posted: Tue May 17, 2011 12:01 am

Yeah I guess that could confuse some people even if the title does say draglink. This arvo will be fine, other parts are getting machined today so good timing. The draglink must be straight no bends at all and within half a mil would be accurate enough if you can

Page 1 of 1

[ 6 posts ]

Board index » Talking About Stuff » Suzuki Talk

Who is online

Users browsing this forum: Google [Bot] and 36 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum