auszookers.com
https://www.auszookers.com/forum/

Drag link project
https://www.auszookers.com/forum/viewtopic.php?f=5&t=21824		 Page 1 of 1
Author:  burls [ Tue May 10, 2011 10:08 am ]
Post subject:  Drag link project
Can I get a measurement from bolt centre to bolt centre of a drag link for a 95 sj70 or compatible. I'll load up story after its finished. Measurement from separate sources would be good to ensure accuracy
Author:  burls [ Mon May 16, 2011 9:34 am ]
Post subject:  Re: Drag link project
Bump
anyone handy with a tape measure and a sj70 zook with a straight drag link could do this for me. please
Author:  steak_knife [ Mon May 16, 2011 12:37 pm ]
Post subject:  Re: Drag link project
burls wrote:
Can I get a measurement from bolt centre to bolt centre of a drag link for a 95 sj70 or compatible. I'll load up story after its finished. Measurement from separate sources would be good to ensure accuracy


if your talking tie rod "bolt center", it will be different from car to car, as this will change with wheel alinement...
Author:  burls [ Mon May 16, 2011 9:40 pm ]
Post subject:  Re: Drag link project
Thanks for that but what I really want is the length of a straight Draglink from bolt centre to eye centre
Author:  zooky08 [ Mon May 16, 2011 10:59 pm ]
Post subject:  Re: Drag link project
Bolt to bolt is the tie rod
That's what u said first
So you want the measurements for the drag link which goes from steering box to tie rod

If you can hold on until this arvo I can get a rough measurement
Mines out of the car ATM
Author:  burls [ Tue May 17, 2011 12:01 am ]
Post subject:  Re: Drag link project
Yeah I guess that could confuse some people even if the title does say draglink. This arvo will be fine, other parts are getting machined today so good timing. The draglink must be straight no bends at all and within half a mil would be accurate enough if you can
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/