| auszookers.com https://www.auszookers.com/forum/ |
|
| dizzy drive cam gear size https://www.auszookers.com/forum/viewtopic.php?f=5&t=21460 |
Page 1 of 1 |
| Author: | jonno_racing [ Fri Apr 29, 2011 9:45 am ] |
| Post subject: | dizzy drive cam gear size |
hey guys i need to get a new shaft made up for a angle drive kit. can some one run the verniers over the end of the cam where the drive gear is pressed on? |
|
| Author: | skyman [ Sat Apr 30, 2011 6:20 am ] |
| Post subject: | Re: dizzy drive cam gear size |
If a standard 1.3 head will work give me a shout tomorrow and I can mic it out for you. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|