auszookers.com https://www.auszookers.com/forum/
bump stops in a vitara https://www.auszookers.com/forum/viewtopic.php?f=5&t=17909	Page 1 of 1

---

Author:	Brett [ Sat Jan 01, 2011 9:15 am ]
Post subject:	bump stops in a vitara
does any one know if there is a off the shelf bumpstop that is about 25mm in the front and 30 - 40 mm in the rear bigger than stock that will fit a lwb 95 vitara? the 31's are going on and thought i'd see if there is any instead of putting a spacer in there

---

Author:	royce [ Sat Jan 01, 2011 9:17 am ]
Post subject:	Re: bump stops in a vitara
arb do a 25mm (I think) front spacer for the XL7, which should fit a vit front and rear on the back I used some rhs cut with a holesaw to slide inside the spring and bolted the bumpstop to it and it to the bumpstop

---

Author:	atari4x4 [ Sat Jan 01, 2011 9:18 am ]
Post subject:	Re: bump stops in a vitara
there is an OME bumpstop, not sure on the length. ARB part #FK28, most ARB stores have no idea ARB/OME make it. http://auszookers.com/index.php?name=Fo ... y+bumpstop

---

Author:	christover1 [ Sat Jan 01, 2011 10:29 am ]
Post subject:	Re: bump stops in a vitara
http://www.bits4vits.co.uk/store/VITARA ... d_118.html http://www.bits4vits.co.uk/store/VITARA ... od_35.html

---

Author:	Brett [ Sun Jan 02, 2011 3:08 am ]
Post subject:	Re: bump stops in a vitara
i'm more after a replacement bumpstop than spacers. i'll go check out the arb one this week some time

---

Author:	got_bar_work [ Sun Jan 02, 2011 7:40 pm ]
Post subject:	Re: bump stops in a vitara
Abt do some nice ones but I'm not sure if the thread is right Might have to weld a new nut on and drill out the old one

---

Author:	DarkHorse [ Mon Jan 03, 2011 10:07 am ]
Post subject:	Re: bump stops in a vitara
If you can find an ARB stockist who will 1) admit that they exist and 2) agree to order some in for you grab a pair for me too.

---

Page 1 of 1	All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/