| auszookers.com https://www.auszookers.com/forum/ |
|
| UHF arial lead through the firewall to the bonnet?? https://www.auszookers.com/forum/viewtopic.php?f=5&t=17671 |
Page 1 of 1 |
| Author: | NickOff [ Wed Dec 22, 2010 12:17 am ] |
| Post subject: | UHF arial lead through the firewall to the bonnet?? |
ok, UHF wired up and working! now wheres the best spot to get through the fire wall out under the bonnet?? thanks and its a 1990 sierra... |
|
| Author: | royce [ Wed Dec 22, 2010 12:22 am ] |
| Post subject: | Re: UHF arial lead through the firewall to the bonnet?? |
Grommet passenger side corner of the firewall dont use the holes down lower meant for AC pipes, its messy |
|
| Author: | ck13488 [ Wed Dec 22, 2010 12:28 am ] |
| Post subject: | Re: UHF arial lead through the firewall to the bonnet?? |
+1, at the top. Runs straight out to the front corner, then out through the hole in the front passenger corner to easily mount on the bull bar. |
|
| Author: | bazook [ Wed Dec 22, 2010 1:23 am ] |
| Post subject: | Re: UHF arial lead through the firewall to the bonnet?? |
or just go through the gromet for the bonnet that should stretch enough to go through |
|
| Author: | DarkHorse [ Mon Dec 27, 2010 4:48 am ] |
| Post subject: | Re: UHF arial lead through the firewall to the bonnet?? |
I went straight through the grille with the spottie wires. Realised the error when I pulled the front apart to mount the winch. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|