| auszookers.com https://www.auszookers.com/forum/ |
|
| Axel and Gears ID! https://www.auszookers.com/forum/viewtopic.php?f=5&t=16330 |
Page 1 of 1 |
| Author: | remydog05 [ Fri Oct 29, 2010 10:29 pm ] |
| Post subject: | Axel and Gears ID! |
I have found a set of cv's and axels but Im not sure what they are from as they came with a car i bought a while back. Anyone know lengths and splines etc? I think they maybe NT 1.3 but not 100% Did a search and keep find transgear info! 
Also have what I think is a 2 sets of 5.12 fronts but again I will need the tooth count to confirm what they are. I found this to solve the 5.1 problem http://auszookers.com/index.php?name=Fo ... ooth+count What about tooth count for 3.7 or 3.9?? |
|
| Author: | SuziBlu [ Fri Oct 29, 2010 11:05 pm ] |
| Post subject: | Re: Axel and Gears ID! |
Count both, ring and pinion teeth, then divide the ring by the pinion. |
|
| Author: | remydog05 [ Sun Oct 31, 2010 2:35 am ] |
| Post subject: | Re: Axel and Gears ID! |
Axels anyone?? |
|
| Author: | remydog05 [ Mon Nov 01, 2010 10:26 pm ] |
| Post subject: | Re: Axel and Gears ID! |
Bump?? |
|
| Author: | steak_knife [ Tue Nov 02, 2010 6:01 am ] |
| Post subject: | Re: Axel and Gears ID! |
I don't have any N/t axle's, but I'll go measure some w/t's next smoke break.. Just rear's?? |
|
| Author: | remydog05 [ Tue Nov 02, 2010 8:19 pm ] |
| Post subject: | Re: Axel and Gears ID! |
steak_knife wrote: I don't have any N/t axle's, but I'll go measure some w/t's next smoke break..
Just rear's?? Thanks mate Not rear, Im 99% sure they are a set of Fronts. |
|
| Author: | steak_knife [ Wed Nov 03, 2010 6:10 am ] |
| Post subject: | Re: Axel and Gears ID! |
long side ( passenger) 670 to the inner race of the cv short side(driver's) 340 to the inner race of the cv. Pick is of the long side & the inner race/spider gear. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|