auszookers.com
https://www.auszookers.com/forum/

g13ba vac lines around the carby
https://www.auszookers.com/forum/viewtopic.php?f=5&t=13536		 Page 1 of 1
Author:  needmorelift [ Wed Jul 14, 2010 5:25 am ]
Post subject:  g13ba vac lines around the carby
anyone got pics of where the lines SHOULD go? i think i might some of mine the wrong way round...
Author:  needmorelift [ Wed Jul 14, 2010 9:23 am ]
Post subject:  Re: g13ba vac lines around the carby
no one? also theres a pipe that comes out of the bottom of the fuel pump i dont have anything going into that...does anyone know what is meant to go in there?
Author:  JrZook [ Wed Jul 14, 2010 9:27 am ]
Post subject:  Re: g13ba vac lines around the carby
needmorelift wrote:
no one? also theres a pipe that comes out of the bottom of the fuel pump i dont have anything going into that...does anyone know what is meant to go in there?


Nothing it stays open so the diafram can pulsate
Author:  losfer [ Wed Jul 14, 2010 9:48 am ]
Post subject:  Re: g13ba vac lines around the carby
how about you take some pics and i tell you whats wrong ...

funny story , car yard ... they buy a fuel pump off me , fit it , car still plays up , running out of fuel , their mechanic stuffs around for days , they blame new fuel pump/ faulty etc , i said bring the car to me , pop bonnet , vacuum line fitted to the pipe on fuel pump , hilarious
Author:  Rusho [ Wed Jul 14, 2010 9:53 am ]
Post subject:  Re: g13ba vac lines around the carby
losfer wrote:
how about you take some pics and i tell you whats wrong ...

funny story , car yard ... they buy a fuel pump off me , fit it , car still plays up , running out of fuel , their mechanic stuffs around for days , they blame new fuel pump/ faulty etc , i said bring the car to me , pop bonnet , vacuum line fitted to the pipe on fuel pump , hilarious


That's pure gold :rofl: :rofl: :rofl: :rofl: :rofl:
Author:  needmorelift [ Wed Jul 14, 2010 10:27 am ]
Post subject:  Re: g13ba vac lines around the carby
yeah sorry stupid memory card in the cam was playing up..

i think this side is fine its the other side closer to rocker cover

Image

bottom left goes to the dizzy and the one above that goes to the charcoal canister and far right goes to some diagphram above the alt??
Image

whats this plug for? :S the old owner went through and ripped all the connections off and half of them are just bare wires now...
Image
Author:  losfer [ Wed Jul 14, 2010 10:46 am ]
Post subject:  Re: g13ba vac lines around the carby
ok the top 2 are pretty much right , except swap the charcoal canister and dizzy vacuum lines around

that plug is for the anti dieseling solenoid and dash pot , i will try and explain ...

the anti dieseling solenoid cuts fuel to the idle circuit to prevent run on or "dieseling" , the two wires that run to it , one needs power when you turn the ignition on the other is an earth , you should hear it click when you turn the ignition on. without this hooked up the car wont idle , if it does idle , its because someone has removed the solenoid from the carby and cut the end off to disable it , in this case the car will most likely run on when shut off ..

the dash post is an emmision control feature , its to stop "excess hydrocarbons" primarily , it also helps to stabilise idle control. what it does is stop the throttle from snapping shut when the accelerator is released , its a nice feature , but not that important
Author:  losfer [ Wed Jul 14, 2010 10:48 am ]
Post subject:  Re: g13ba vac lines around the carby
one more thing ..
see the little valve in between the vacuum line on no 1 pic , the green bit should face the other way
Author:  needmorelift [ Wed Jul 14, 2010 10:59 am ]
Post subject:  Re: g13ba vac lines around the carby
cheers losfer i'll get onto it...that plug though has a green wire as well as a black one and a white and black wire...am i right in assuming the green needs volts and the other too need to be earthed?

it would kinda explain why it doesnt hold idle
Author:  losfer [ Thu Jul 15, 2010 10:20 am ]
Post subject:  Re: g13ba vac lines around the carby
will reply to your pm ..
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/