[Trent1]

hey all
just wandering if anyone knows how to get my sierras transfer case out of 4h as it got stuck after pulling the lever out and putting it back in it wont move and the selector bush is fine

any advise will be great thanks trent

does a 1990 selector shifter for the transfer case fit into a 1994 transfer case

[Ben_Sierra]

You can't just shove the level back in, you need to line up the gates properly, how did you put it back in?

[Trent1]

if the gates had moved how would i realine them

[fordem]

With a large screwdriver.

[Trent1]

thanks fordem is this fairly easy

[Ben_Sierra]

See the rods inside the shifter hole? They have little notches in them, you need to stick a screwdriver in there and move them around into the right spot, then just slot the shifter in!

[Trent1]

righto thanks for that i will have a go at it later on today

[Trent1]

all sorted out it was just the gates had moved so we put a screwdriver down it and they clicked into position
Thanks for your help trent