| auszookers.com https://www.auszookers.com/forum/ |
|
| wheel bearings https://www.auszookers.com/forum/viewtopic.php?f=5&t=11654 |
Page 1 of 1 |
| Author: | Bucket [ Sat May 08, 2010 2:36 am ] |
| Post subject: | wheel bearings |
Yesterday I got some bearings pressed into my front rotors. I've tried putting them on already but have a bit of a conundrum, I either tighten the nut on the shaft so the locknut fits and then its very hard or almost impossible to move the rotor around. OR have the locknut barely in the groove so it can spin a bit. Is there any chance they've fucked up putting them in, or that the bearings are completly different? There weaves' bearings and he assured me they were right. |
|
| Author: | royce [ Sat May 08, 2010 3:02 am ] |
| Post subject: | Re: wheel bearings |
the washer behind it isnt rubbing is it? with only pressure against the inner races as tight as it can go it should still turn |
|
| Author: | Bucket [ Sat May 08, 2010 3:05 am ] |
| Post subject: | Re: wheel bearings |
Ummm, not sure. Are you refering to that big circle washer that has two flat sides opposite each other? Both sides seem to be doing the same thing |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|