| auszookers.com https://www.auszookers.com/forum/ |
|
| G16A with tbi convert to carburetor https://www.auszookers.com/forum/viewtopic.php?f=37&t=57640 |
Page 1 of 1 |
| Author: | Ο μητσις [ Fri Mar 01, 2024 10:42 am ] |
| Post subject: | G16A with tbi convert to carburetor |
Hello ,everyone. I bought an SJ80 had a G16A 8v with a single point injection . I fiddled with it and I fried one of my pistons . I don't have the time or the knowledge to deal with it now . So I bought a vitara with a G16A 8v carburetor engine . I deleted the high pressure fuel pump, I pit on ISC 500 ohms resistor . I have fuel ,I have power from coil to distributor but no ignition. Should I use the vitaras ignition coil and ecu too . Timing is right I appreciate any ideas . I'm reading how to recalibrate the efi system but I will refurbish my old block and install the engine back in the future |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|