| auszookers.com https://www.auszookers.com/forum/ |
|
| column switch problems https://www.auszookers.com/forum/viewtopic.php?f=37&t=56833 |
Page 1 of 1 |
| Author: | Gussyb [ Wed Jan 06, 2021 12:33 pm ] |
| Post subject: | column switch problems |
I just got a new column switch because the headlights didn't work with the old one. everything else worked. I connected it up and the windscreen washers/wipers, horn and headlights work but now the hazard lights and indicators don't work. my car is a Holden drover and I bought a Sierra switch. I was told that it wouldn't fit my drover and it didn't. the mounting points were wrong. I drilled parts so they would fit and i'm sure that the circuit board wasn't hit. Anyone got any idea Thanks Gus |
|
| Author: | 4x4xzook [ Fri Feb 05, 2021 10:39 am ] |
| Post subject: | Re: column switch problems |
Check the listing you bought. https://www.ebay.com.au/itm/COMBINATION ... SwZn1fkYgh This says its for a holden drover, did you buy the right column switch? |
|
| Author: | fordem [ Fri Feb 05, 2021 11:04 am ] |
| Post subject: | Re: column switch problems |
WHY are you starting a new thread on this? https://auszookers.com/forum/viewtopic.php?f=37&t=56818 Is this the same switch or a new one? I got you the relevant diagrams, everything you needed to sort the problem out, or at the very least determine that the switch was not compatible - perhaps it's time to take the car to an auto-electrician. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|