Might be handy for some, plenty of ways of doing this so it's far from gospel. I went this way so I could run an optima for winching duties, and squeeze a compressor and fuse block beside the brake booster.
First up is to make space on the inner passenger side gaurd, to do this the radiator over flow and wiper washer bottle both need to be relocated.
Gently remove the radiator spot welds, and trim the bracket back as per the photos below. It then fits neatly in beside the airbox with a nutsert.
The washer bottle is a little trickier but easily replaced with the bottle from an ABS model that sits inside the inner gaurd.
This may become an issue when I go to bigger tires, time will tell.
I made a bracket to hold my VSR off the strut brace, used because I found it in my shed.
Bashed in inner gaurd mostly flat and made a tray to hold the optima. used factory bolts/captive nuts for the the tray mounting.
Re-ran the starter and charging cables(this was painfull doing it neatly) And no detailed photo's of either sorry, next time I pull the battery I'll edit the post.
Optima red top on the gaurd, and 130ah N70 in the stock position....
