| auszookers.com https://www.auszookers.com/forum/ |
|
| F10A 1.0 electronic distributor conversion https://www.auszookers.com/forum/viewtopic.php?f=37&t=35778 |
Page 1 of 1 |
| Author: | jonno_racing [ Mon Sep 17, 2012 10:25 am ] |
| Post subject: | F10A 1.0 electronic distributor conversion |
hey guys i have a sierra electric dizzy to go in my f10a it has a resistor on the coil, do i need to remove it and install or is there any other tricks? Phil |
|
| Author: | Jackson [ Mon Sep 17, 2012 11:33 am ] |
| Post subject: | Re: F10A eletric dizzy conversion |
I just used the 1.3 coil and dizzy and took the ballast resistor out. |
|
| Author: | jonno_racing [ Mon Sep 17, 2012 3:45 pm ] |
| Post subject: | Re: F10A eletric dizzy conversion |
Jackson wrote: I just used the 1.3 coil and dizzy and took the ballast resistor out. cheers is the wiring the same color? |
|
| Author: | Jackson [ Mon Sep 17, 2012 5:11 pm ] |
| Post subject: | Re: F10A eletric dizzy conversion |
Not sure, mine is a Maruti Dizzy which has a black wire with white stripe that goes to positive side of the coil and a brown wire which goes to the negative. Then a black wire at the base of the dizzy housing which I just ran to the body. The wiring diagram on Suzuki Info says it is black wire with white trace that goes to positive side of the coil, brown with white trace to negative of the coil. |
|
| Author: | jonno_racing [ Mon Sep 17, 2012 6:29 pm ] |
| Post subject: | Re: F10A eletric dizzy conversion |
thanks very much mate |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|