| auszookers.com https://www.auszookers.com/forum/ |
|
| Start up issues https://www.auszookers.com/forum/viewtopic.php?f=37&t=35233 |
Page 1 of 1 |
| Author: | Lukeszook [ Sat Aug 25, 2012 9:03 am ] |
| Post subject: | Start up issues |
Ok so.. from time to time when i start up the sierra it does one of the following. A. starts normally. B. Starts but there is a weird descending buzz which goes on for about 3 secs after start up. C. Doesn't start up just makes a loud grind noise. Auto choke has been taken out btw. Any ideas on what i can do to fix it? |
|
| Author: | abclarke [ Sat Aug 25, 2012 9:19 am ] |
| Post subject: | Re: Start up issues |
Sounds like a similar problem i had, i just got a new starter off ebay and problem solved |
|
| Author: | KEENSY85 [ Mon Aug 27, 2012 6:48 am ] |
| Post subject: | Re: Start up issues |
Check ur leads from ur batery to starter if the lead to the starter is frayed or loose it can cause that effect , also buddy try and tap her on the side if the starter don't smash it but just tap it a little and the solanoid I used to do that with my last zook every 6 months saved me some cash. And if u buy a new starter buy a g16 one as the fit the 1.3 and if u every part her out ill get some money back on it also id u do g16 conversion. U have a starter allready , there the same price so why not |
|
| Author: | Reubs [ Mon Aug 27, 2012 11:31 am ] |
| Post subject: | Re: Start up issues |
abclarke wrote: Sounds like a similar problem i had, i just got a new starter off ebay and problem solved x2, sound like the starter motor gear is sometimes not engaging fully on the flywheel and sometimes not disengaging properly. A new starter should fix that (if flywheel gear is ok), or you could try taking the starter apart and re-greasing the sliding parts. Water/mud can get in there and gum it all up. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|