| auszookers.com https://www.auszookers.com/forum/ |
|
| Oil leak https://www.auszookers.com/forum/viewtopic.php?f=37&t=34631 |
Page 1 of 1 |
| Author: | Deego [ Wed Aug 01, 2012 7:32 am ] |
| Post subject: | Oil leak |
My oil sump has been leaking for a while now so I put a new sump gasket in.also my main seal has been replaced not long ago.but there is still an oil leak around the sides and bottom of the gearbox.any ideas what this might be. |
|
| Author: | BlueSuzy [ Wed Aug 01, 2012 8:34 am ] |
| Post subject: | Re: Oil leak |
Rear main again Sump not sealed properly Gearbox input seal Gearbox input casing not sealed right Small plate on back of motor leaking |
|
| Author: | stockman [ Wed Aug 01, 2012 8:44 am ] |
| Post subject: | Re: Oil leak |
Also check dizzy seals. When they go oil runs down the back or the motor. |
|
| Author: | Deego [ Wed Aug 01, 2012 9:27 am ] |
| Post subject: | Re: Oil leak |
I've been.its been doing this for a while now.ive checked my oil levels and I'm not loosing any.when I had the sump leak could there be oil in the gearbox housing and the fly wheel flicking the oil out. |
|
| Author: | abclarke [ Wed Aug 01, 2012 9:35 am ] |
| Post subject: | Re: Oil leak |
Are you sure it's not old oil from beforehand? |
|
| Author: | BlueSuzy [ Wed Aug 01, 2012 9:47 am ] |
| Post subject: | Re: Oil leak |
BlueSuzy wrote: Gearbox input seal
Gearbox input casing not sealed right |
|
| Author: | Deego [ Wed Aug 01, 2012 9:54 am ] |
| Post subject: | Re: Oil leak |
I'm pretty sure its not.it's been doing it for a while,so I'm sure the old oil would have gone by now surely. |
|
| Author: | caboose [ Wed Aug 01, 2012 9:57 am ] |
| Post subject: | Re: Oil leak |
clean it. take it for a blatt, and see if the oil leak comes back |
|
| Author: | Deego [ Wed Aug 01, 2012 10:03 am ] |
| Post subject: | Re: Oil leak |
Can I clean it without taking the gearbox out.it won't hurt it if I spray decreased in the housing. |
|
| Author: | caboose [ Wed Aug 01, 2012 11:09 am ] |
| Post subject: | Re: Oil leak |
At it. Not in it. Try to avoid the electrics as well |
|
| Author: | KEENSY85 [ Wed Aug 01, 2012 5:17 pm ] |
| Post subject: | Re: Oil leak |
look at were ur shifter bolts also the prevouse might not have bolted the shifter plate up properly and might be spashing out |
|
| Author: | Deego [ Wed Aug 01, 2012 5:33 pm ] |
| Post subject: | Re: Oil leak |
It's coming from inside the gearbox where the metal plate cover is,that covers your fly wheel. And it's definitely engine oil |
|
| Author: | mrw82 [ Wed Aug 01, 2012 6:14 pm ] |
| Post subject: | Re: Oil leak |
Rear main seal. That's a gearbox out job to replace. |
|
| Author: | KEENSY85 [ Wed Aug 01, 2012 6:50 pm ] |
| Post subject: | Re: Oil leak |
mrw82 wrote: Rear main seal. That's a gearbox out job to replace. pretty easy job for ya 30min ether way |
|
| Author: | Deego [ Wed Aug 01, 2012 7:02 pm ] |
| Post subject: | Re: Oil leak |
Ok thanks mate. |
|
| Author: | Deego [ Wed Aug 01, 2012 7:04 pm ] |
| Post subject: | Re: Oil leak |
It's been doing it for a while but I'm not loosing any oil |
|
| Author: | want33s [ Thu Aug 02, 2012 6:52 am ] |
| Post subject: | Re: Oil leak |
Deego wrote: It's been doing it for a while but I'm not loosing any oil If you weren't losing ANY oil you wouldn't have a leak, would you? Even one tablespoon of oil is enough to make a mess but not enough to notice down on the dipstick. Engine oil coming out of the bottom of the bellhousing is a leaky rear main seal as has been said a few times already. |
|
| Author: | Scales [ Fri Aug 10, 2012 11:58 am ] |
| Post subject: | Re: Oil leak |
i rekon its the rear main seal.... anyone else? |
|
| Author: | TZAR [ Fri Aug 10, 2012 12:04 pm ] |
| Post subject: | Re: Oil leak |
rear main seal
|
|
| Author: | atari4x4 [ Fri Aug 10, 2012 12:11 pm ] |
| Post subject: | Re: Oil leak |
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|