auszookers.com • View topic - M13A to G13BA Jimny power steering pump bracket

Board index » Talking About Stuff » I made it and fabrication

M13A to G13BA Jimny power steering pump bracket

Page 1 of 1

[ 4 posts ]

Print view

Previous topic | Next topic

Author

Message

coily96

az supporter

Joined: Wed May 05, 2010 11:50 am
Posts: 823
Location: Beenleigh
Vehicle: Coil Sierra

Posted: Mon May 11, 2015 10:10 pm

I've been working on an adapter to fit a M13A Jimny power steering pump to a G13BA block.

Since the G13BB and Vitara pump are a direct fit, the M13A pump required some modification to fit the G13BA block.

If there is any interest, after the bracket is finished I can have a run of these laser cut.

There is a few modifications to the original M13A bracket due to the shape and size, as well as designing the mount so the pump can tilt and work as a tensioner for the belt.

dougies_tx5turbo

Joined: Tue May 25, 2010 10:56 am
Posts: 1051
Location: north brisbane

Posted: Mon May 11, 2015 11:32 pm

Must of miss your want add i would swap m13a bracket for your g13bb one if you still interested in one i am in Strathpine

coily96

az supporter

Joined: Wed May 05, 2010 11:50 am
Posts: 823
Location: Beenleigh
Vehicle: Coil Sierra

Posted: Wed May 13, 2015 7:55 pm

Hey, ive only got a M13A bracket. Never had a G13BB hence why ive made a bracket to use the M13A on a G series motor.

coily96

az supporter

Joined: Wed May 05, 2010 11:50 am
Posts: 823
Location: Beenleigh
Vehicle: Coil Sierra

Posted: Sat May 16, 2015 11:44 pm

The pump is on, just need to sort out the top bracket so it tensions the belt.

Page 1 of 1

[ 4 posts ]

Board index » Talking About Stuff » I made it and fabrication

Who is online

Users browsing this forum: No registered users and 6 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum