| auszookers.com https://www.auszookers.com/forum/ |
|
| custom power steer and endless air https://www.auszookers.com/forum/viewtopic.php?f=14&t=3470 |
Page 1 of 1 |
| Author: | jimbo_jones [ Thu Dec 04, 2008 2:55 am ] |
| Post subject: | custom power steer and endless air |
I needed a power steer pump for the zook but and I got hold of a std A/C pump and bracket so I decided to make a set up out of the 2 I welded a piece of 10mm flat bar to the a/c bracket which I bent in the press to suit then I got a EA falcon power steer pump and made a bracket to hold it the end result 
|
|
| Author: | jimbo_jones [ Fri Dec 05, 2008 2:37 am ] |
| Post subject: | Re: custom power steer and endless air |
the finished product 
|
|
| Author: | smileysmoke [ Fri Dec 05, 2008 4:14 pm ] |
| Post subject: | Re: custom power steer and endless air |
wow good work mate i wish i had the skills to do that stuff.. it looks sturdy as! |
|
| Author: | jimbo_jones [ Thu Dec 11, 2008 11:50 pm ] |
| Post subject: | Re: custom power steer and endless air |
smileysmoke wrote: wow good work mate i wish i had the skills to do that stuff.. it looks sturdy as!
thanks I still might have to put a tensioner in there to give it more wrap on the a/c pully |
|
| Author: | want33s [ Fri Jan 02, 2009 3:48 am ] |
| Post subject: | Re: custom power steer and endless air |
jimbo_jones wrote: thanks I still might have to put a tensioner in there to give it more wrap on the a/c pully 110-120 degrees of belt wrap on the pulley is usually the minimum recommended. The more the better obviously but see how you go. Jas. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|